CyberT 0 Posted April 12, 2022 Dear Sir We are testing Tinker Board 2 with Debian 10 V2.0.3 and Node-Red v2.2.2 and we found contrib-tinkeros-gpio on Node-Red can get GPIO input from Tinker Board 2 but error when send GPIO output as below picture. If you have experience to solve this case, could you please share for me Refer GPIO input work Share this post Link to post Share on other sites
yi-hsin_hung 3 Posted May 18, 2022 Hi @CyberT: The config table's naming of asus gpio input and output node are for Tinker Board S. And, the packages are development by third party member(https://github.com/tinycore-hisanori/node-red-contrib-tinkeros-gpio). But, i think it is compatible with Tinker Board 2 about gpio pin number. You can replace the attachment file to /home/linaro/.node-red/node-moduels/red-contrib-tinkeros-gpio/nrgpio.sh file and asus output node would work by add sudo permission for Tinker Board 2. Please help to try and verify it. Thank a lot! nrgpio.sh 1 Share this post Link to post Share on other sites
CyberT 0 Posted June 10, 2022 Hi @yi-hsin_hung Thank you very much for your information and help to modify nrgpio.sh for me. we stop node-red service and replace the nrgpio.sh (attachment file) to /home/linaro/.node-red/node-moduels/red-contrib-tinkeros-gpio/nrgpio.sh file then start node-red service again and found asus output node can work properly on Thinker Board 2 I think your nrgpio.sh file very helpful to make Thinker Board 2 control DO, DI with Node-Red easily. Share this post Link to post Share on other sites
yi-hsin_hung 3 Posted June 13, 2022 Hi @CyberT: Have nice day! It's good information for us and wish you have good experience on Tinker Board 2. ^_^ Share this post Link to post Share on other sites
Mamoun 0 Posted September 28, 2022 (edited) Hi I have the same issue with tinker edge R, I replaced the attached file but still GPIO don't work in nodered Thanks in advance Edited September 28, 2022 by Mamoun Share this post Link to post Share on other sites