Jump to content


  • Content Count

  • Joined

  • Last visited

Posts posted by elvis

  1. Hi onayg,

    This code seems to be prepared for Asus Tinker, not Edge. It also requires additional circuit to be connected. In my opinion it will not work here 😞

    The only solution I've found until now is to disconnect fan, otherwise noise is too annoying for me. But during boot fan is running slower, so there seems to be some way to control rotation speed. Just I have no idea how.

  2. Tinker Edge R is very interesting board, unfortunately cooling fan running at full speed all the time makes playing with this board very painful experience.

    Is there any method to reduce fan speed? In fact it should be possible to run even with passive cooling most of the time, ToyBrick doesn't need active cooling at all. Maybe fan should be used only in case of temperature increase?

  3. Thank you for the answer, I will test board with RPi cam then.

    However you wrote:

    3 hours ago, FredYu said:

    MIPI CSI0 is set for OV5647 camera as default.
    MIPI CSI1 is set for IMX219 camera as default.

    It makes a lot sense to use two different cameras for testing, but in more real scenario it would be nice to connect both cameras of the same type.

    How can I change "default" settings? Will it just work if I connect two OV5647 cameras for example?

  4. Edge R board is equipped with two, 22-pins CSI interfaces. Unfortunately I couldn't find any information which camera type is compatible with this board. Can I connect regular Raspberry Pi cam or it requires something special?

    It would be also nice to know how to enable camera under Linux and Android. Do you have any documentation related to camera interfaces?

  • Create New...