Jump to content

Search the Community

Showing results for tags 'audio input volume soundcard mic'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General
    • Announcements
  • Tinker Board 3N
    • General Discussion
    • Hardware
    • Software
  • Tinker V
    • General Discussion
  • Tinker Board 2 series
    • General Discussion
    • Hardware
    • Software
    • Android
  • Tinker Board / Tinker Board R2.0 series
    • General Discussion
    • Hardware
    • Software
    • Android
  • Tinker Edge T
    • General Discussion
    • Hardware
    • Software
  • Tinker Edge R
    • General Discussion
    • Hardware
    • Software
    • Android

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me

Found 2 results

  1. Hi, I want to use I2S with Max98357 (with 3W 4ohm speaker) this is pin i use connect to Max98357 LRC ------------ I2S0_FS (35) BCLK --------- I2S0_SCLK (12) DIN ------------ I2S0_SDO0 (40) GAIN ---------- Float SD ------------- Float GND ---------- GND VIN ------------ VCC5 (2) and I also config on Tinkerconfig to turn on I2S but nothing happend Please help me
  2. Hello there. We are trying to use the tinkerboard as an ADC connected via Ethernet. We are using tinker os (debian). Аn electrodynamic microphone is connected to jack 3.5 . The sound card driver successfully detects the microphone and allows audio recording from it. The problem is that the amplitude of the input signal is too high and distorsion is observed. As you can see in the picture below. Usually this problem is solved by reducing the gain of the analog amplifier of the sound card. However, if you adjust the microphone gain via "pulse audio" or "alsa", the amplitude is reduced, but the distortion remains. This means that the gain control is done digitally. Those. the resulting amplitude is simply divided by some coefficient But this behavior is wrong. All sound cards have a controllable amplifier before of the ADC. OS gain control should use it to control input gain. I'm not very good at Linux programming, but it seems to me that this is a bug in the sound card driver. Or it is necessary to use some other library to access the gain. Or it is necessary to adjust something in the OS itself so that the gain works correctly. The question is what needs to be done to use the analog preamplifier of the sound card? Thanks for attention
×
×
  • Create New...