Nott 0 Posted September 7, 2022 I don't know how to set lirc on tinker board 2s. because it is different from raspberry pi. In raspberry pi the settings is: add below code in config.txt: # Uncomment this to enable infrared communication. dtoverlay=gpio-ir,gpio_pin=17 dtoverlay=gpio-ir-tx,gpio_pin=18 The definition of the tinker board 2s pin is different from the raspberry pi, so I don't know how to modify it Hardware:Tinker board 2s OS:Tinker Board 2 Debian 10 V2.1.6 Share this post Link to post Share on other sites