Yakiug
-
Content Count
6 -
Joined
-
Last visited
Posts posted by Yakiug
-
-
On 6/22/2023 at 2:07 AM, tooz said:hello @Yakiug,
are the logs kept? may i have a look at it?
I don't know. How can i see the logs?
-
I installed and tested it and when I used the apt update and apt upgrade command, the board shut down. After a few days I installed again in the eMMc the same version and did not use the commands to update the board did not turn off. However, I disconnected and connected the board and the system did not start again.
-
I am using it as normal, just plug it in, install the system on the eMMc or SD, but it turns off after 10 to 15 minutes on, I can't install anything.
In maskrom mode it recognized the board after many attempts and i am installing the system.
After waiting for a while I always get the same error, that the system can not be installed, when I try to run from the SD I have to make several attempts to disconnect and connect the board so that it can start the system.
-
There is no file in the OS section of the board.
I was installing this file Tinker_Board_2-Debian-Buster-v2.0.14-20220823.
Every time I try to use the board , it turns on for a period of time and shuts down. Then it can not turn on , it turns on randomly . I have already tried using a SD card and the same thing happens.
-
I'm trying to reinstall the OS. I'm using Balena to flash the device, but every time I connect it, my computer doesn't recognize it. It used to recognize it when I changed the system before, but not anymore. I also tried using an SD card as the manual suggests, but I'm encountering the same error with the eMMC.
eMMC is not recognized for installing the OS on the Tinker Board 2S.
in Hardware
Posted
I found this
syslog