Hello
Has any one used IMX219 8MP camera with Tinkerboard or Tinkerboard S hardware?
Please kindly provide me information about how to connect and use imx219 8MB camera.,
In my /boot/config.txt i haven't seen any info about how to set/activate camera on the device. There is a section for loading device tree overlays (I assume these are kind of device drivers) but could"n find any information on the internet,
Even I do not know how to activate them there are "camera-ov5647-overlay.dts" and "camera-ov5647-overlay.dtbo" files In the /boot/overlays folder .
There is no file for `imx219`, so does that mean tinkerboard and tinkerboard s do not support imx219 cameras at all?
here is my boot config.txt:
##### Hardware Interface Config #####
## Note: fiq_debugger and uart3 use the same pin. Set fiq_debugger first while both on. ##
## Note: uart4 and spi0 are the same pins. Set the latter one while both on. ##
## Note: uart2 is the same pins to pwm2 and pwm3. Set the latter one while both on. ##
intf:fiq_debugger=on
#intf:i2c1=off
#intf:i2c4=off
#intf:spi0=off
#intf:spi2=off
#intf:pwm2=off
#intf:pwm3=off
intf:pcm_i2s=on
#intf:uart1=off
#intf:uart2=off
#intf:uart3=off
#intf:uart4=off
##### Driver Config #####
## Note: auto_ums: Auto enable ums mode while power on with USB connected. ##
conf:auto_ums=on
##### Tinker Power Management #####
cpu_governor=ondemand
a17_minfreq=126000
a17_maxfreq=1800000
gpu_governor=simple_ondemand
t76x_minfreq=200000000
t76x_maxfreq=600000000
##### List of device tree overlays to load. Format: overlay=<dtbo name, no extension> <dtbo2> ... #####
## Note: Put dtbo files under the overlays folder. ##
overlay=
Any help is really appreciated
