Jump to content

Search the Community

Showing results for tags 'mipi'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General
    • Announcements
  • Tinker Board 3N
    • General Discussion
    • Hardware
    • Software
  • Tinker V
    • General Discussion
  • Tinker Board 2 series
    • General Discussion
    • Hardware
    • Software
    • Android
  • Tinker Board / Tinker Board R2.0 series
    • General Discussion
    • Hardware
    • Software
    • Android
  • Tinker Edge T
    • General Discussion
    • Hardware
    • Software
  • Tinker Edge R
    • General Discussion
    • Hardware
    • Software
    • Android

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me

Found 2 results

  1. Hello Has any one used IMX219 8MP camera with Tinkerboard or Tinkerboard S hardware? Please kindly provide me information about how to connect and use imx219 8MB camera., In my /boot/config.txt i haven't seen any info about how to set/activate camera on the device. There is a section for loading device tree overlays (I assume these are kind of device drivers) but could"n find any information on the internet, Even I do not know how to activate them there are "camera-ov5647-overlay.dts" and "camera-ov5647-overlay.dtbo" files In the /boot/overlays folder . There is no file for `imx219`, so does that mean tinkerboard and tinkerboard s do not support imx219 cameras at all? here is my boot config.txt: ##### Hardware Interface Config ##### ## Note: fiq_debugger and uart3 use the same pin. Set fiq_debugger first while both on. ## ## Note: uart4 and spi0 are the same pins. Set the latter one while both on. ## ## Note: uart2 is the same pins to pwm2 and pwm3. Set the latter one while both on. ## intf:fiq_debugger=on #intf:i2c1=off #intf:i2c4=off #intf:spi0=off #intf:spi2=off #intf:pwm2=off #intf:pwm3=off intf:pcm_i2s=on #intf:uart1=off #intf:uart2=off #intf:uart3=off #intf:uart4=off ##### Driver Config ##### ## Note: auto_ums: Auto enable ums mode while power on with USB connected. ## conf:auto_ums=on ##### Tinker Power Management ##### cpu_governor=ondemand a17_minfreq=126000 a17_maxfreq=1800000 gpu_governor=simple_ondemand t76x_minfreq=200000000 t76x_maxfreq=600000000 ##### List of device tree overlays to load. Format: overlay=<dtbo name, no extension> <dtbo2> ... ##### ## Note: Put dtbo files under the overlays folder. ## overlay= Any help is really appreciated
  2. Hi, I was wondering, what MIPI/CS-2 cameras are supported by Tinkerboard 2S? Is there a list somewhere? Are typically cameras supported by Raspberry Pi supported by Tinkerboard 2S as well? Have anybody try to make Tinkerboard 2S drives/runs 4 cameras? How's the performance? I found this in Amazon, is it something that Tinkerboard 2S supports? https://www.amazon.com/CS-TX2-XAVIER-nCAM-IMX385-Jetson-Devkit-Xavier-YT1-0-5-1/dp/B09DB8786P/ Thank you.
×
×
  • Create New...