Jump to content

Search the Community

Showing results for tags 'debian11'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General
    • Announcements
  • Tinker Board 3N
    • General Discussion
    • Hardware
    • Software
  • Tinker Board 3 Series
    • General Discussion
    • Hardware
    • Software
    • Android
  • Tinker V
    • General Discussion
  • Tinker Board 2 series
    • General Discussion
    • Hardware
    • Software
    • Android
  • Tinker Board / Tinker Board R2.0 series
    • General Discussion
    • Hardware
    • Software
    • Android
  • Tinker Edge T
    • General Discussion
    • Hardware
    • Software
  • Tinker Edge R
    • General Discussion
    • Hardware
    • Software
    • Android

Calendars

  • Community Calendar

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me

Found 4 results

  1. Distro: Debian Bullseye OS: Linux 5.10.198 Arch: Arm64 GPU: Mali Midgard T-860 Driver: libmali-midgard-t86x-r18p0-wayland-gbm Hello! Trying to launch a browser session from a systemd service. I'm getting this error when I try to run the service. [ 175.756156] rockchip-vop ff900000.vop: [drm:vop_crtc_atomic_enable] Update mode to 1920x1080p60, type: 11 [ 175.756243] asus_write_resolution_to_file: HDMI failed to open file What's causing this and how do I fix it? Or how do I debug it?
  2. I've tried multiple solutions but have come up short on all of them. Right now I'm trying to get the WPEWebkit cog browser going. So far, no luck. I can get it to "start" in a Weston session (I've installed the Wayland libMali driver from the RockChip repo). However, it only displays an on-screen keyboard and no browser. Any suggestions?
  3. Hello How do I enable the serial console on tinker board 3N? I'm running TinkerOS Debian 11, I'm trying to enable LVDS output on the uboot without success. Any suggestions?
  4. Hello, When we put "intf:fiq_debugger=off" line to config.txt and removed WiFi card (as the device we're sending to our customers does not require WiFi/BT, TInkerBoard simply won't boot. It's stuck after the messages about cfg80211 loading certificates (as shown in the attached photo). Do you have maybe any solution or workaround for this issue? Best regards, Jovan
×
×
  • Create New...