peterkwon 1 Posted September 19, 2022 Kernel Build Questions in Tinker Edge T I installed Mendel 5 Eagle V3.0.2 on Tinker Edge T. I want to change Boot Logo of Tinker Edge T, and I want to communicate with UART device in Mendel Linux. To change the Boot Logo, Kernel must be compiled. Where can I download the kernel source for Mendel 5 Eagle V3.0.2? And, what do I need to do to communicate with the UART device in mendel linux? Guid documentation says /dev/ttymxc0 and /dev/ttymxc2 should exist, but I see /dev/ttymxc0 and /dev/ttymxc1. If /dev/ttymxc1 is checked, it is said to be incorrect. I need help with the above two. regards. Share this post Link to post Share on other sites