[Urgent][Debian 11 - 3.0.11][TinkerBoard 2S] OS reads only Date from the RTC clock. The time is zero (00:00) when read from RTC

[Jovan 0]

 

Hello,

We're having issues with reading date&time from RTC clock.

Battery is connected, voltage is measured and is ok. 

 

 

We can set the date&time in RTC clock using command "hwclock --systohc" as you can see in screenshot below:

But our issue is that after the reboot, only the date is read from RTC clock.

After the reboot, time starts every time at 00:00:00 even though it was written to RTC before the reboot.

This is plain vanilla Debian OS and we're having this issue consistently on more than one device.

Any ideas?

 

Thanks a lot.

Edited June 4 by Jovan

[tooz 52]

hello @Jovan, 

this issue has been fixed in v.3.0.16, please use this version (or any version later than v.3.0.16) and give it a try. the latest os released is v.3.0.18: 

Tinker Board 2 /2S Debian 11 (kernel 5.10) v.3.0.18

[Jovan 0]

@tooz thanks for the prompt response.

Tried and tested it, and yes, it solved our issue.

?